I installed the TDK VeloCD 48x internal burner in my system, and It is recognized in the bios, on startup, it detected the drive, installed the drivers for TDK CDRW4800B , then gave me an error saying: "FOUND NEW HARDWARE A problem occurred during hardware installation. This device may not work properly." In device manager, drive properties says, "This device cannot start. (Code 10)" In 'My Computer' here is what is displayed... (link to image) http://www.cloud10.org/gallery/data/500/30wheresmycdrw.jpg
NOthing changes if I uninsall and reinstall the drive through device manager. Drive is on Secondary IDE as master, and a CD-ROM drive is on slave, jumpers are set correctly. Tryed drive by itself as master and cable select and no jumpers, same problem.
I would appreciate any help anyone can provide... Thank you!
System specs: This is a new system that I built...
XP Pro SP1
P4 2.53 mhz
Soyo P4X400 mobo
Muskin 512 PC3200 DDR400 Ram
TruPower550 PSU
Abit ti4600 video card
SB Audigy Soundcard
52x CD-ROM
TDK VeloCD 48x internal CD-RW
1.44 floppy
linksys NIC
etc...
Error - Signature not found -
NOthing changes if I uninsall and reinstall the drive through device manager. Drive is on Secondary IDE as master, and a CD-ROM drive is on slave, jumpers are set correctly. Tryed drive by itself as master and cable select and no jumpers, same problem.
I would appreciate any help anyone can provide... Thank you!
System specs: This is a new system that I built...
XP Pro SP1
P4 2.53 mhz
Soyo P4X400 mobo
Muskin 512 PC3200 DDR400 Ram
TruPower550 PSU
Abit ti4600 video card
SB Audigy Soundcard
52x CD-ROM
TDK VeloCD 48x internal CD-RW
1.44 floppy
linksys NIC
etc...
Error - Signature not found -