Good morning everyone. I just recently picked up a DIR-655 to replace my WRT54GL, hoping that I could get a better stream in my house. The house is 100 years old with plaster and lathe, and I can't relocate the modem and router. So I figured I could use my old WRT54GL as a signal booster/access point on the second level of the house. I read through a couple of guides, and I could get the router to broadcast the signal with full bars, and I could attach to it, but I didn't get any internet. I'm going to attach as many screenshots as I can of both routers in hopes that someone can point out what I'm doing wrong. The D-Link is a DIR-655 with firmware 2.10NA. The Linksys is a WRT54GL with Tomato 1.28. Here are a couple screenshots for the DIR-655:
Here are the Linksys WRT54GL Screenshots. I went ahead and reset this router and updated to 1.28 so that I would have a clean slate for retrying the setup:
Sorry for the wall of screenshots, but I know in looking through some other tutorials, not all Tomato firmwares have the same options, so I'm hoping this makes it easier. I really appreciate any help I can get on this, so my wife will get of my back about not being able to stream Homeland to the living room!