/ Sign-up
Your question


  • Hard Drives
  • Storage
Last response: in Storage
December 24, 2002 11:43:38 AM

Replaced old hdd with maxtor 40gb 7200rpm hdd using the maxblaster software that came with it.Once i created c:p artition i was presented with the c prompt,it now doesnt seem to understand dos commands.Also get the message'invalid drive specifaction' when i try setup,also 'NOT ENOUGH DRIVE LETTERS AVAILABLE'Tried moving boot devices around in the bios but no joy.All jumpers and cables correct as i removed drive and replaced with old drive and everthing is fine.HELP

More about : install

December 24, 2002 2:27:26 PM

Did you format it?

:smile: Good or Bad have no meaning at all, depends on what your point of view is.