Access Points going Default

[Vanadil]

Hi everyone,

Bit of an odd one. I have some network devices that are connected to a 110v power source that goes through a 110v/5v power converter.

The Access points keep going back to factory default settings and losing their configuration. I have the same access points installed in the same situation but on a different site that work fine.

I have changed both the configuration and firmware to be be identical to the working Access Points and still the others default.

They do not do this at a specific time of day and out of the 6, they do this at random and not at the same time. Sometimes they will go 24 hours + without defaulting, sometimes they'll go just 4 hours.


Any ideas at all are welcome!

Thanks


Vanadil

 

[hang-the-9]

If you can, swap an access points between sites, does the issue follow the hardware or stay with the site no matter what is installed there? That will tell you where the issue is.

 

[Vanadil]

That's what I'm planning to try this week as I'm out of other ideas / options!