I get low signal when I connect my preamp to 002 someone can help?

Hi I have a problem when I connect my universal audio solo 610 to the analog inputs of the digidesign 002.

This is the way i do it:

1.- conect a mic with cable XLR to the preamp ( mic is a condenser and have the 48v phanton power of the preamp on)
2.- conect a cable XLR/ TRS from the preamp to the 002
3. I set volume and gain up and I can record but the signal is to low doesnt have volume

Then I just conect my premp to the inputs of the 002 that have preamp and sounds good but in that way I m mixing the sounds of the 2 preamps.

am I missing something else to get gain? Somebody have an idea of what is happening here?

after you record your data go to audio suite and select normalize. itll bring it way up without burning it