8BD - Repair person - Sleeve PN

[Guest]

Archived from groups: rec.games.pinball (More info?)

Does anyone know if there is someone in the Longview, Washington area that
repairs pins?

Also, would Steve at Pinball Resource have the little sleeve that is near
the end of the kicker (just above the flipper) shaft? This is not a coil
sleeve, it's the tiny plastic guide or sleeve that keeps the shaft centered.
I have a cracked one and the plastic piece that pushes the ball against the
rubber wants to stay out against the rubber when it's activated. If will go
back but not right away (1-5 seconds or so). I wrapped a piece of wire
around the plastic sleeve to compress it a bit & it works now but I need to
replace it. God forbid if I don't have a part number for Steve so, does
anyone know what the pn would be for this sleeve or at least a good,
accurate description?

Thanks

Reed

 

[Guest]

Archived from groups: rec.games.pinball (More info?)

I'm finding it hard to follow your description, but I think you may be
asking about the nyliner that sits in the flipper assembly, the flipper
plunger is guided through the nyliner.

If this is what you are after PBR does have them, just decribe what you are
after to Steve, that's what I did.


"Reed" <reed.wi@gte.net> wrote in message
newsd_Ce.20745$IJ1.11715@trnddc02...
> Does anyone know if there is someone in the Longview, Washington area that
> repairs pins?
>
> Also, would Steve at Pinball Resource have the little sleeve that is near
> the end of the kicker (just above the flipper) shaft? This is not a coil
> sleeve, it's the tiny plastic guide or sleeve that keeps the shaft
centered.
> I have a cracked one and the plastic piece that pushes the ball against
the
> rubber wants to stay out against the rubber when it's activated. If will
go
> back but not right away (1-5 seconds or so). I wrapped a piece of wire
> around the plastic sleeve to compress it a bit & it works now but I need
to
> replace it. God forbid if I don't have a part number for Steve so, does
> anyone know what the pn would be for this sleeve or at least a good,
> accurate description?
>
> Thanks
>
> Reed
>
>