IRQ not less or equal

When I try to setup the CPU frequency to OC, I counter this error when using machines. What does the error means

Probably not the pci divider, i have gotten that one at speads that i know my pci cards to run at.


If it isn't a P6 then it isn't a procesor
110% BX fanboy

Howcome PCI because it is CPU not mobo freq.

Ms knowledge base:
<A HREF="http://support.microsoft.com/default.aspx?kbid=130802" target="_new">General Information on STOP 0x0000000A</A>
<A HREF="http://support.microsoft.com/?kbid=165863" target="_new">Microsoft Knowledge Base Article - 165863 </A>
<A HREF="http://support.microsoft.com/?kbid=314063" target="_new">Troubleshooting a Stop 0x0000000A Error in Windows XP</A>
<A HREF="http://support.microsoft.com/?kbid=183169" target="_new">Possible Resolutions to STOP 0x0A, 0x01E, and 0x50 Errors</A>

This error message usually means that a device driver is trying to access invalid memory areas. In other words: some buggy device driver. Sometimes you can solve it by rearranging your PCI cards (therewith reassigning IRQs etc, and so reinstalling the drivers in another combination of resources), sometimes by updating your device drivers.

Or the RAM is faulty, or if you're overclocking too much:
<A HREF="http://support.microsoft.com/?kbid=271955" target="_new">STOP 0x4E, STOP 0x1A, STOP 0x50, and STOP 0xA Errors Occur When You Try to Start the Computer</A>

Another source: If you installed Win2k or XP next to another windows installation (on the same partition)
<A HREF="http://support.microsoft.com/default.aspx?scid=kb;en-us;227301" target="_new">STOP: 0x0000000A When You Dual Boot with Windows NT 4.0 on the Same Partition</A>

Another source: Roxio Easy CD Creator <A HREF="http://support.microsoft.com/default.aspx?scid=kb;en-us;311466" target="_new">Computer Automatically Restarts After You Upgrade to Windows XP</A>

Yeah its gotta be that PCI ration, which is usually on a 1:5. Probably need to set it to 1:6 if you get the clock speeds up there.

F-DISK-Format-Reinstal DO DA!! DO DA!!

i disagree, i normally get this message just from plain old overclocking my cpu too far.


If it isn't a P6 then it isn't a procesor
110% BX fanboy

Yes, the core of the original socket 4 pentium was the P5, the newer socket 5 version was the P54, the Pentium MMX core was the P55C, and every core from the Petnium Pro to the last PIII was therefore called P6 architecture.

<font color=blue>Only a place as big as the internet could be home to a hero as big as Crashman!</font color=blue>
<font color=red>Only a place as big as the internet could be home to an ego as large as Crashman's!</font color=red>