Backglass repair

[Guest]

Archived from groups: rec.games.pinball (More info?)

I have a backglass which has an area the size of your thumb which has
lifted. The piece in still attached to the backglass on one side of the
"chip". What is the best way to secure the piece so it lays flat? The
piece is arched a bit so I am not sure if TT will weigh it down. Should
I put some glue under the piece?

Thanks,

-Tom

http://mysite.verizon.net/vze8f4tt/tomstwilightzonepinballmachineaccessories/index.html

 

[Guest]

Archived from groups: rec.games.pinball (More info?)

If you spray triple thick on it with just a little extra on that area
wait abiut 3./4 mintues then take saran wrap about twice the size ofthe
spot and lay it own on top of it you can flatten it out and you can
actually move it a little to match up the seems. wait 24 hours then
pull off the saran wrap. ive done this several times and it works
great. it doesnt work real good unless theres a place for the triple
thick to get under the paint to hold it down. if its just bubbled with
no seperation it doesnt work as well. you can go to marvins .com and
there is a section on this. trick is not to pull off the saran wrap
until it is completely dried. just my opion