Sign in with
Sign up | Sign in
Your question

Saitek Cyborg Keyboard - How to open?

Last response: in Computer Peripherals
Share
Anonymous
December 18, 2010 10:50:17 AM

Hello,
I'd like to open my Cyborg Keyboard to clean it inside. But at the back side of keyboard I'm unable to disjoint the bottom from the upper side. I have doubt using force, I don't want to break it (I love the keyboard:) . I've searched the internet, but found no video nor solution:( . Have you some experience with opening the keyboard?
Thank you a lot for all your suggestions.
Anonymous
December 18, 2010 11:14:25 AM

If you suspect it uses concealed clips between the mouldings (sometimes there's a small gap letf to show where) run a penknife down the seam.

First check there are no screws to release -- may be hidden under label or rubber feet.
October 2, 2012 11:30:52 PM

Quote:
Hello,
I'd like to open my Cyborg Keyboard to clean it inside. But at the back side of keyboard I'm unable to disjoint the bottom from the upper side. I have doubt using force, I don't want to break it (I love the keyboard:) . I've searched the internet, but found no video nor solution:( . Have you some experience with opening the keyboard?
Thank you a lot for all your suggestions.



Under back ruber feet is hiden screw on both sides of the keybord. But is nothing to clean over there. Just take compres air and blow all out without opening. I did it and just broke one of the lifter and then I had to use compressor anyway.
!