unable to use scandisk after updating ZoneAlarm

Archived from groups: alt.sys.pc-clone.dell (More info?)

After I restart the system and the final black screen comes up to begin
checking the disk, I get this message:

"Cannot open volume for direct access."


"bullseye" <bullseye35@deletetheextrastuff@excite.com> wrote in message
newsIvtc.144886$WA4.33996@twister.nyc.rr.com...
>
>
> Using a Dell Dimension 4100, W2K pro, 512 meg ram, 80 gig hard disk; just
> updated the free version of ZoneAlarm to version 5, defragmented fine,
> scanned for virus fine, but ScanDisk goes back to boot up after the
initial
> screen. Could ZoneAlarm be interfering? What else could it be?
>
>

Archived from groups: alt.sys.pc-clone.dell (More info?)

Thank you for the tip. I will uninstall version 5 and revert back to 4.5.



"Edward J. Neth" <ejn63@netscape.com> wrote in message
news:mowtc.4415$Ss6.4105@newssvr32.news.prodigy.com...
> Get rid of ZA5 and go back to 4.5 until they solve the problems with it.
>
> The upgrade has problems with too many programs to even begin naming them
> all.
> For a quick glimpse, take a look at the support forums on www.zonelabs.com
>
>
>
> "bullseye" <bullseye35@deletetheextrastuff@excite.com> wrote in message
> newsIvtc.144886$WA4.33996@twister.nyc.rr.com...
> >
> >
> > Using a Dell Dimension 4100, W2K pro, 512 meg ram, 80 gig hard disk;
just
> > updated the free version of ZoneAlarm to version 5, defragmented fine,
> > scanned for virus fine, but ScanDisk goes back to boot up after the
> initial
> > screen. Could ZoneAlarm be interfering? What else could it be?
> >
> >
>
>