Hey guys I just got me an AMD Athlon Barton XP 3200+ for my system which includes a Shuttle AN35N-Ultra Motherboard supports up to 400mhz FSB.
So I install my chip today, it's a retail one with fan and all and I keep running into the same problem. I'll install it and it shows AMD Athlon XP 1100+ I'm like ok np just need to change FSB so I go into Bio change it from like 100 to 133 bam! My computer shuts off and a red light next to where my power supply connects into my bored lights bright and the only way I can run my computer again is to take out the back power supply to outlet wire and back in again, clear cmos, then start again. I'll try running it in diff fsb again, ok this time I got it up to amd athlon xp 1900+. Few seconds in, computer shuts off, red light glows. I even try to start my computer at it's default/failsafe mode at amd athlon xp 1100+. After windows starts to load, bam! Shuts down again.
So I'm posting this on my old amd athlon xp 2400+ looking for some help, thx much. Any help is appreciated.
So I install my chip today, it's a retail one with fan and all and I keep running into the same problem. I'll install it and it shows AMD Athlon XP 1100+ I'm like ok np just need to change FSB so I go into Bio change it from like 100 to 133 bam! My computer shuts off and a red light next to where my power supply connects into my bored lights bright and the only way I can run my computer again is to take out the back power supply to outlet wire and back in again, clear cmos, then start again. I'll try running it in diff fsb again, ok this time I got it up to amd athlon xp 1900+. Few seconds in, computer shuts off, red light glows. I even try to start my computer at it's default/failsafe mode at amd athlon xp 1100+. After windows starts to load, bam! Shuts down again.
So I'm posting this on my old amd athlon xp 2400+ looking for some help, thx much. Any help is appreciated.