So I have two problems with my monitor (TVera TS-27WQHDIPS).
The first problem is that the power connection is extremely dodgy and will cut power to the monitor if my table even shakes slightly. I always have to really push hard on the cable then move my hand away slowly so that it will not turn off. Secondly the pixels will all randomly turn to black sometimes but my guess is that this is also from the connection when it only half disconnects so the monitor is still on but not receiving enough power. I have looked at the port on the monitor and the end of the power cable and they both look fine which is why I am hesitating to order a new power brick. Any ideas?[flash=560,315]http://www.youtube.com/v/3qXUmHwvSuE?version=3&hl=en_US[/flash]
The first problem is that the power connection is extremely dodgy and will cut power to the monitor if my table even shakes slightly. I always have to really push hard on the cable then move my hand away slowly so that it will not turn off. Secondly the pixels will all randomly turn to black sometimes but my guess is that this is also from the connection when it only half disconnects so the monitor is still on but not receiving enough power. I have looked at the port on the monitor and the end of the power cable and they both look fine which is why I am hesitating to order a new power brick. Any ideas?[flash=560,315]http://www.youtube.com/v/3qXUmHwvSuE?version=3&hl=en_US[/flash]
Facebook
Twitter
Instagram