How to reset the password on a Kyocera Mita FS1000+ network interface?

[arthur-quantize]

I've bought a Kyocera Mita FS1000+ second hand, and it prints fine through the parallel port as an HP compatible but not as a Kyocera! I could administer it via the network interface card but it has a password on - this also means I can not reconfigure it to work on my network's subnet.

Does anyone know a master password or way to reset the printer to factory defaults which would allow me to configure it as I require?

Many thanks!

 

[arthur-quantize]

I was wondering whether to start unscrewing this to see if there is a reset jumper - anyone know about that as an option perhaps, or any similar printers that might have a method?

Cheers!