Processor design

Can some one explain something for me?
Well remember the older athlons and p3's than used a slot instead of a socket? Why did they stop making the cpu's this way? It seems like it would be Ideal for keeping them cool because there are 2 more sides and much more surface area. It seem like the cooling needs of some new cpu's (like when they get to 5GHz er something) would need more of it.

If an orange was driving a racecar would it peel out? www.jxfiles.com

I beleave slot had the cache around the cpu on the board. And socket had ondie cache. Where slot cache was like 1/3 2/3 the speed of the cpu and the cache on the socket was the same speed as the cpu. Which is why you dont see as much cache. Unless you start looking at the newer cpus.

Yeah the on-die cache situation was why they changed when you could run the cache at twice the speed as a slot processor it was a bit of an advantage to bad you got about half the L2 cache

AMD XP 1900+
A7V-333
Geforce 3 TI 200
PC2100 512MB

Not really, the current Northwood processor and the Tualatin processor have 512KB cache.

<b><i>"A penny saved is a penny earned!"</i></b>

You must not have seen a P4's heat sink. Try fitting even just one of those onto a slot-based processor and you'd be called nuts. To try and put one on front and one on back though would be just plain crazy.

No, the cooling needs of new CPUs is best handled by a huge freaking heat sink. Slot processors could never support something like that. Size and weight of a heat sink are very limited by slot processors.


Tech support said take a screen shot.
Putting it down with my .22 was the humane thing to do.