Hmm, you kinda lost me there. Its does show the card as 12x1, 5vp. If I check off BIT 01, it changes to 16x1, 5vp. But upon reboot is back again. Should I make it 16x1,4vp? Even if I do check these off, the state remains the same, ENABLE or DISABLED.
Did you put a checkmarh in the box that says.
Allow enableing of hardware masked units????
Then click "customize" button.
On my card bit 02 ,Pixel unit 2 was dissabled or hardware masked. (yours may be different)
Click on the Hardware masked units. The corresponding bit entry at the top will highlight. Type a 1(one). Now do this for the Vertex unit. Same thing click on the hardware masked uni. And type a 1(one).
You are about to answer a thread that has been inactive for more than 6 months. If you still wish to proceed, please ensure that your posting is original and does not duplicate or overlap any prior responses to this thread.