problem with Symbol LA-4111 PCMCIA and CISCO 1220B Access ..

Archived from groups: alt.internet.wireless (More info?)

Make sure encryption is disabled. If you need to, try only to use 56 Bit
because 128 is different for each AP. There is no standard for 128 Bit so
each vendor uses their own version of it.

Michael

"Simon" <swmcmanus@hotmail.com> wrote in message
news:3a7e5d95.0404190007.34378ce9@posting.google.com...
> Hi all,
> This is a bit of an obscure post but here goes anyway:
>
> I have been doing some testing with a couple of Symbol PCMCIA cards
> that I got hold of recently and I would like to see if anyone else can
> confirm my suspicions.
>
> I was doing some testing at 128bit encryption to see how the Symbol
> cards did working with non Symbol Access Points. I had a CISCO AP1220b
> available at the time from a friend and decided to try that. It turns
> out that the LA4111 would not even associate with the CISCO AP. I had
> a Symbol LA-4121 too so I tried that. This card works perfectly fine
> at 128bit encryption.
>
> Then I tried the same test without the encryption and it turns out
> that the LA-4111 once again would not associate. (it works fine with
> a Symbol access point). The LA-4121 associates and works fine without
> encryption and with both access points.
>
> The long pre-amble parameter was correctly configured for the CISCO
> access point so that was not the problem.