system board agp support????

[Rubberbband]

I ran PCILIST and it's results state that my system board supports 1x agp. My board is a Gigabyte 7vm with Via chipset that supports 1x, 2x and 4x agp. These settings also appear in the Bios (recently flashed) and I have the most recent Via 4 in 1 drivers installed. What gives????? How do I set it to 2X (which is currently enabled in BIOS)????

Here are the results:CPU speed - 699 MHz
DirectX - initialized
AGP revision - 2.00
VGA IRQ - IRQ11, not shared
AGP aperture - 64MB
System board AGP transfer support - 1x
Graphics card AGP transfer support - 1x, 2x
AGP traffic currently enabled - 1x
System board SBA - supported
Graphics card SBA - supported
AGP sideband currently enabled - yes
Pipelined transactions - supported, queue depth of 32
Fast write protocol - n/a

Devices:
VIA CPU bridge (03051106h)
VIA PCI bridge (83051106h)
VIA ISA bridge (06861106h)
VIA IDE controller (05711106h)
VIA USB (30381106h) - IRQ9
VIA SMBus (30571106h)
Creative Labs audio device (00021102h) - IRQ10
Creative Labs input controller (70021102h)
Realtek Ethernet controller (802910ECh) - IRQ9
SGS Thomson VGA controller (0010104Ah) - IRQ11

PS My Video card is a Hercules Prophet 4500 64 Mb

 

[Rubberbband]

I'm replying to my own post because I found the solution. I DL Powerstrip beta 3 which confirmed the problem. So I re-installed the VIA 4 in 1 drivers and noticed that you can instal in TURBO mode which I did and I no longer have a problem. Just passing on the info!!!