IRQ setting not shown after loading

First off thanks to everyone who posted answers and advice on my post of "What did I do wrong". Each one was a huge help with my problem. Buuuuuuutttt!! I have just figured that I did the ultimate No-brainer mistake when it comes to computer systems. I wasnt thurough enough!!! My GF 2 MX200 card has driver conflict error code 24 after I load it. Have tried many drivers, even un-clocked the system backl to original specs. I just noticed something today,...I cant find under properties in device manager a IRQ setting for the graphics card. None are listed, I guess now I see why the cards not working properly. Daaahhhh!....I checked my older system and the graphics card there shares a IRQ setting with the PCI steering!! Should this G-card Im trying to load have the same IRQ eg...Shared with PCI steering?? I have 15 IRQ settings listed and each one is filled with one or more items. I guess my question is "can I assign the IRQ setting for PCI steering to this card and have them both share this setting?? And the last question is....How di I do that??
I apologize to everyone that attempted to help me with this proplem from earlier post, I wasnt thurough enough on my troubleshooting, I have just never heard of an item like this being loaded without an IRQ setting being assigned to it. Thanks to all again

Warb-the-Snapped

---------------------FIXED------------------------------

Finally!!!!!!!!!!!!!!!!!!!

That last bit of info from Toejam solved the problem. It would have been solved way way sooner if I would have just payed attention to details. Thanks again to all that attempted to help me out, especially Toejam and Crashman!

Warb-the-Snapped