Sign in with
Sign up | Sign in
Your question

New ti4400 *Remote procedure call failed" Whaaa?

Last response: in Graphics & Displays
Share
Anonymous
a b U Graphics card
May 1, 2002 11:19:31 PM

Hi everyone.
Well, I just got a new card, the Leadtek Gf4 ti4400, and loaded it up on my XP box. I am using the 28.32 dets.

Well, i went to try and install 3Dmark2001SE, but when it came time for the actual installation, it hung up. After I CTRL-ALT-DEL, and end it, I get a pop-up that says "The Remote procedure call failed". What?

So, I sucessfully installed Commanche4, and it ran fine. So I go to try and install "Ghost Recon" but the same "Remote procedure call failed" happens.

I can't find ANYTHING on this problem on the web. Have any of you seen it?

Man, I wait 2 years for a new card, and this is KILLING me! :( 

Any help would be GREATLY appreciated!

thanks everyone!

Butch
May 3, 2002 7:36:04 PM

Remote Procedure Call reminds me of RPC, something involving networking or involved by networking. I don't think it has got something to do with your new vid-card. Maybe try re-installing your drivers, maybe your windows or in the end, try reinstalling your entire computer (format c:, you know), thiugh I know that's quite a aggressive approach.

Good Luck!
Bikeman

<i>Then again, that's just my opinion</i>
!