help setting up system, please

[Guest]

Hello,
I recently got a bunch of new components to upgrade my system. Specifically, an abit-kr7a raid, athlon xp 1700, 256 ddr, and 2 60gb maxtor drives. Anyways, I mounted the board in the new case, put in the drives, got the other stuff from my old system, etc.. Finally, when I turned on the power the system starts repeating a long beep, and the monitor is never turned on. I've tried taking out all non essentials but same thing. I know the graphics card (radeon) works since i'm using it now. I could not find any mention in the Abit manual so i'm at a loss. Perhaps, if someone knows what that beep means or what's going on they could help me out. Thank you,
Showcaser

 

[hardwarefreek]

One beep is usually the RAM refresh (from Abits website)

 

[hardwarefreek]

Here is the whole thing:
Number of beeps

Meaning of error
1 DRAM refresh is not working.
2 Parity circuit is not working or parity status bits are not cleared when parity is disabled.
3 First 64k memory test failure. Address line test (A0..A15) failure.
4 System timer is not counting properly.
5 Processor register/flag test failure.
6 8042 keyboard controller gate-A20 error.
7 Processor exception error encountered.
8 Display memory R/W test failure (NON-FATAL)
9 ROM-BIOS checksum error.
10 CMOS Shutdown Register R/W error.