Linksys WRT54G WEP Problems

Archived from groups: alt.internet.wireless (More info?)

Yes, its a centrino processor with an Intel wireless card.


--
goose
brought to you by http://www.wifi-forum.com/
1 answer Last reply
More about linksys wrt54g problems
  1. Archived from groups: alt.internet.wireless (More info?)

    if you're using windows zero configuration double click on the little
    connection status icon and click on properties and a properties panel will
    come up. select the wireless network tab, click on configure and on the page
    that comes up there should be currently "wep" in the authentication box.
    change this to wpa-psk and encryption to tkip.

    you'll then just need to type in a plaintext passphrase rather than some
    cryptic long key.

    go to your wrt54g and go through similar stuff and use the same plaintext
    passphrase.

    it usually took a few seconds for everything to start working once you
    closed all the windows of the configuration process. i found if i didn't
    close all the windows it didn't begin working.

    good luck

    jtm

    "goose" <goose.19gf7n@no-mx.forums.yourdomain.com.au> wrote in message
    news:goose.19gf7n@no-mx.forums.yourdomain.com.au...

    Yes, its a centrino processor with an Intel wireless card.


    --
    goose
    brought to you by http://www.wifi-forum.com/
Ask a new question

Read More

Wireless WEP Linksys Processors Internet Wireless Networking