Sign in with
Sign up | Sign in
Your question

Lan Extender Problems

Last response: in Networking
Share
September 16, 2013 2:43:27 AM

Hello,

I have a LAN extender to extend my network (Patton diamond link 3201) ,recently i began to lose the connection between the 2 connected buildings , when i check the device i find in the wan part the link is ON but the TX and RX leds not blinking by restarting it works fine, but it happen again and again,sometimes i need to reboot the 2 devices, does a broadcast on the network can cause this issue?

More about : lan extender problems

September 17, 2013 5:34:26 PM

If only rebooting fixes the issue, you may have a faulty device at either end. Do you have a spare to swap out and test?
December 9, 2013 4:21:50 AM

MartinWilson said:
If only rebooting fixes the issue, you may have a faulty device at either end. Do you have a spare to swap out and test?


I did a swap with 2 other devices but the problem still exist ,can the line itself has problem? does LAN broadcasting cause this?
!