Hello, I have a GTX 780 and want to hook up 2d surround to it. I am getting red x's next to all three displays when I go to configure the set up. I have a...
Qnix qx2710 27inch 1440p - Hooked up with a DVI-D cable
Asus VS248H-P 24inch 1080P - Hooked up with HDMI (Through an HDMI matrix)
Asus VE248H 24inch 1080p - Hooked up using a passive DP to HDMI
I read a bunch of places that it is possible to use a 1440p monitor with two 1080p monitors, I would just need to set the resolution of the 1440p to 1080p. (I also read you couldn't, so I am not sure what is right). I have tried this with no luck. For some reason my Qnix monitor defaults to 59hz and when I change it to 60hz with the other monitors enabled it gives me a yellow screen.
I also read that I might need an active displayPort to HDMI/DVI instead of a passive.
Any help is greatly appreciated.
Qnix qx2710 27inch 1440p - Hooked up with a DVI-D cable
Asus VS248H-P 24inch 1080P - Hooked up with HDMI (Through an HDMI matrix)
Asus VE248H 24inch 1080p - Hooked up using a passive DP to HDMI
I read a bunch of places that it is possible to use a 1440p monitor with two 1080p monitors, I would just need to set the resolution of the 1440p to 1080p. (I also read you couldn't, so I am not sure what is right). I have tried this with no luck. For some reason my Qnix monitor defaults to 59hz and when I change it to 60hz with the other monitors enabled it gives me a yellow screen.
I also read that I might need an active displayPort to HDMI/DVI instead of a passive.
Any help is greatly appreciated.