Computer Turns on but nothing display on monitor

[adam2112]

Hey everyone,

This build has been working fine for the last 2 months, but after removing a wireless network card (didn't need it anymore) nothing will display but the computer is clearly on (LEDs, fans, hard drive, CPU fan all are going).

When I first completed the build I had the same problem, and I found the only solution to be to using a DVI cable plugged in to an old Samsung monitor, and then once Windows started switching to my hdmi and new AOC monitor. I tried this again but nothing is displaying on either monitor.

Specs:
CPU: FX-8320 Eight-Core 3.5GHz
Motherboard: ASUS M5A97 R2.0
RAM: 2x AMD 4GB 1333MHz
PSU: Ultra LSP Series V2 750-Watt
Graphics: XFX Radeon R7 260X
Case: NZXT Phantom 410

Any help would be great!

 

[Jay Lavistria]

You may have knocked loose a connector.
Disconnect and reattach video cables tightly to the R7 260X.
If it doesnt work, connect cables to the motherboard and run in safe mode to reinstall drivers.

 

[adam2112]

If this helps, when I turn the computer on the gpu fan turns on but goes off almost immediately

 

[Jay Lavistria]

The GPU turns off while everything else runs?
Is your model supported with a zero-speed fan system?

 

[adam2112]

I'm not sure to be honest, but I don't think it is

 

[Jay Lavistria]

Your GPU may be defective.
Test it in another computer (that has NVidia drivers)