I just finished putting together my PC but now I can't get anything to display on the monitor.

[FootlessCthulu]

I put my PC together today and after assembling everything I turn it on and the fans spin and it lights up. But nothing appears on my monitor. I have tried it connected to the GPU with a HDMI cord and connected to the motherboard with a VGA cord. Im very confused. Here are my details:http://pcpartpicker.com/p/DRDCFT

 

[BustaRhymes]

I would check everything on this list. Chances are something isn't getting power. make sure you plugged in the 4 pin connector for your processor.

http://www.tomshardware.com/forum/261145-31-perform-steps-posting-post-boot-video-problems

 

[FootlessCthulu]

I would check everything on this list. Chances are something isn't getting power. make sure you plugged in the 4 pin connector for your processor.

http://www.tomshardware.com/forum/261145-31-perform-steps-posting-post-boot-video-problems

4 pin connector for processor? I plugged in my PSU 8 pin connector into a 4 pin port on my motherboard. Is that wrong?

 

[BustaRhymes]

That should be right. I would take the vid card out and all but one ram stick and try again. Or check things on that link i sent you.

 

[FootlessCthulu]

That should be right. I would take the vid card out and all but one ram stick and try again. Or check things on that link i sent you.

Ok I will do that in the morning. I have a question about number 11 on that disk though. If one of those are bent is the motherboard pretty much done for? Also if I take out the on stick of ram and the video card and it then works, what would I do afterward?