Setup bios gigabyte ultra durable 3 ssd + Raid 0

[Kirillo]

Hello,
I need a help.
I installed windows 7 on samsung 850 Pro 512 gb ssd drive with AHCI enabled in BIOS.
plus I want to install two WD 300 mb hard drives in RAID 0 mode
plus WD 1tb HD.
Thats the plan
Motherboard is Gigabyte ultra durable 3 with 6 SATA2 and 4 SATA3 ports

Now to my question
I have a few BIOS options @ Integrated Peripherals section that I want to be sure I am setting to correct parameters:
Now it is shows:
eXtreme Hard Drive (XHD) [Disabled]
ICH SATA Control Mode [AHCI]
SATA Port0-3 Native Mode [Enabled]
eSATA controller [Enabled]
eSATA Ctrl Mode [AHCI]
GSATA 6_7/IDE Controller [Enabled]
GSATA 6_7/IDE Ctrl Mode [AHCI]
GSATA RAID Configuration [Press Enter]
GSATA 8_9/IDE Controller [Enabled]
GSATA 8_9/IDE Ctrl Mode [AHCI]

Since I have no idea under which setting I should enable RAID controller I
probably doing something wrong.
And I don't want to

My system SSD connected to Sata 2 port on Motherboard
Can I connect my two RAID 0 WD 300Mb hard drives to Marvell Sata 3 ports?
Can I connect my WD 1tb hard drive to Marvell SATA 3 port
I encountered some opinions not to use Marvell SATA 3 ports.
Will appreciate any comments/help on these matters.

 

[GhislainG]

I'd set the Intel controller in RAID and use it for all drives.