This is the first time I have ever used a Cathode Ray Tube monitor, normally I would be using LCDs and LEDs.
However, when I get into the OSD, I encounter menus that are shapes (squares, rhombuses, trapeziums, pararellograms, squares inside squares, squares with arrows in them, weird shapes, funny shapes, etc.) like Ancient Egyptian Language, and values only in percent and numbers.
The OSD is not very self-explanatory. I only know the sun being the brightness, EXIT is ext, MAGNET is degauss, the half moon is constrant, that is it.
This is the picture of my OSD: http://i.imgur.com/45c8SbE.jpg
What i would like is an explaination of each ..."thingy", what they are for and when will i need them.
Thanks a lot.
However, when I get into the OSD, I encounter menus that are shapes (squares, rhombuses, trapeziums, pararellograms, squares inside squares, squares with arrows in them, weird shapes, funny shapes, etc.) like Ancient Egyptian Language, and values only in percent and numbers.
The OSD is not very self-explanatory. I only know the sun being the brightness, EXIT is ext, MAGNET is degauss, the half moon is constrant, that is it.
This is the picture of my OSD: http://i.imgur.com/45c8SbE.jpg
What i would like is an explaination of each ..."thingy", what they are for and when will i need them.
Thanks a lot.