Both monitors on but only one detected!

[UniClad]

I recently reinstalled Windows 7 64bit, and I installed my videos drivers. However, it will not detect my second monitor.

Both monitors are on and they show the same exact screen however when I go into screen resolution only one monitor is detected!

Please help!

 

[i7Baby]

What about in Display Settings?

Post your complete build in detail including OS and monitors.

 

[UniClad]

What about in Display Settings?



Post your complete build in detail including OS and monitors.

http://imgur.com/uwlbpRU

Operating system: Windows 7 Ultimate 64bit

Processor: AMD A10-7850K APU with Radeon R7

Graphics: AMD Radeon R9 200 Series

Monitors: ASUS 24inch & ACER 23 inch

Both monitors worked before the reinstall!

 

[i7Baby]

Did you install your mobo drivers after Windows?

Did you run Detect in Display Settings?

 

[UniClad]

Did you install your mobo drivers after Windows?

Did you run Detect in Display Settings?

Yea i ran Detect but no second monitor appeared and my mobo drivers should be installed. I think it may not be using my primary graphics card.

http://imgur.com/hwAYlbs

Here is my what my device manager shows:
http://imgur.com/UjWq0VQ

 

[i7Baby]

I think it may not be using my primary graphics card. - what card?

Both monitors should be plugged into the graphics card.

 

[UniClad]

I think it may not be using my primary graphics card. - what card?

Both monitors should be plugged into the graphics card.

My AMD Card , it says the 1 monitor that is detected is on my standard VGA.

This is how its plugged in http://imgur.com/SAWuHui

 

[resident TD]

I would bet this is a BIOS setting. I know for a fact the BIOS has a setting for dual monitor support, but a fresh install of your OS shouldn't have reset it. Even so, its worth a look. Hold F2 on boot and navigate to the graphics section. If you don't see something that says "Dual monitor support: disabled/enabled" What do you see?

 

[UniClad]

I was using AMDAutoDetect to install my drivers and for some reason it was detecting the wrong card and installing a driver that wasn't for my hardware. So I had to search for my driver manually and then it was fixed!