New Build X99 4 DIMMs boot fine 8 DIMMs fail to boot

[snowman311]

I have been troubleshooting this for a couple days now and havent made much progress. This is a new build and I am getting a Machine Check Exception after I install windows 7 ultimate 64bit on my first boot after install. I can run any 4 sticks of ram on the left side but if I put the rest or anymore in I get this fault. I tried switching between XMP and default but no luck. I was getting assistance in the systems forum but he sent me here. Any help would be greatly appreciated
Thanks

Here are my components
ASUS RAMPAGE V EDITION 10 LGA 2011-v3 Intel X99
G.SKILL Ripjaws V Series 64GB (8 x 16GB) 288-Pin DDR4 SDRAM DDR4
Intel Core i7-6850K 15M Broadwell-E 6-Core 3.6 GHz LGA 2011-v3
NVIDIA GeForce GTX 1060 6GB GDDR5 PCI Express
SAMSUNG 850 EVO 1TB SATA III 3-D Vertical Internal Solid State Drive
CORSAIR Hydro Series H75 CW-9060015-WW Water / Liquid CPU Cooler 120 MM
EVGA SuperNOVA 750

 

[Tradesman1]

First thought is Memory controller/Channels. Did all 8 sticks come in a single package? Make sure you have the latest BIOS. Try loosening the CPU cooler then snug down screw tight. Many overtight which can put the CPU out of level if a corner or side is over tightened. Also might check the CPU socket for bent/broken pins

 

[snowman311]

First thought is Memory controller/Channels. Did all 8 sticks come in a single package? Make sure you have the latest BIOS. Try loosening the CPU cooler then snug down screw tight. Many overtight which can put the CPU out of level if a corner or side is over tightened. Also might check the CPU socket for bent/broken pins

I have the latest bios installed and no the ram was 2 sets of 4..same product ordered together. I just double checked the cpu again and I do not see any bent pins and it seems to be all of the screws are just snug and I believe they are even.