Hey guys,
I was trying to set up dual boot on my Windows 10 desktop. Current setup is:
256GB SSD C:\
2TB WD D:\
D:\ drive has always shown that it is 2TB in Windows previously. I had created a 100 GB partition on the 2TB WD so I could install Linux Mint. I goofed up and installed the boot files to the drive itself instead of one of the two partitions I created.
Now when I load Windows my D:\ drive shows as 186GB. When I boot Linux from my CD as if I were trying to install again, it shows the drive as 2TB. I have tried using a couple different programs but I haven't had any luck. All help would be appreciated!
I was trying to set up dual boot on my Windows 10 desktop. Current setup is:
256GB SSD C:\
2TB WD D:\
D:\ drive has always shown that it is 2TB in Windows previously. I had created a 100 GB partition on the 2TB WD so I could install Linux Mint. I goofed up and installed the boot files to the drive itself instead of one of the two partitions I created.
Now when I load Windows my D:\ drive shows as 186GB. When I boot Linux from my CD as if I were trying to install again, it shows the drive as 2TB. I have tried using a couple different programs but I haven't had any luck. All help would be appreciated!