To clean disk

tejchaugule658

Prominent
Jan 1, 2018
5
0
510
hello Sir,
My name is Tej and I'm from India. I got an Smart Hard Disk error 301 .
I followed the youtube videos suggesting a fix to this . Below is the detail as to what i have done till now! Could u kindly help me out please!
1)Made a bootable windows 10 USB for 64-bit.
[because when i went to boot manager ,it was showing no boot device found. i even enabled legacy support . Didn't work!]
2)Connected USB , started the setup installation, and i had 7 drive 0 partitions , in that one was system and 3 were primary. tried formatting the primary ones but received error of formatting is not possible.
[basically none of the primary drives accepted the formatting and installing]
3) Opened the CMD, diskpart>list disk> select disk 0 (my primary disk) > clean

it should have cleaned successfully . but i got the following error message:
Diskpart has encountered an error: the request could not be performed because of an I/O device error.
please help . Im stuck at this point.


Thanking you
Yours Sincerely
Tej
 

Colif

Win 11 Master
Moderator
you might be able to boot from a linux live usb and rescue any files that way. I assumed since you tried to run clear on the drive that you were not concerned about anything on drive now.

I had 3 drives die in 2 years, it can be caused by power surges or bad power supplies in general. Or just bad drives. You could look up warranty info on HDD and see if you are covered.
 

tejchaugule658

Prominent
Jan 1, 2018
5
0
510