Need help to correct geometric distortion

Hello all,

I recently purchased a Mitsubishi DiamondView 19NF monitor. There is a noticable distortion at the top of the screen where the picture slants sideways towards the left. It doesn't affect the whole screen just the top 1 - 2 cm. I want to get the most out of my monitor. I have tried to manipulate some of the OSD controls for geometry but I have no idea what I am doing. Apart from the distortion problem the monitor performs reasonably well.

Can anyone help me? I bought the monitor and a few weeks later I found the guide for CRTs here. I wish I had look first before I bought :(.


1 answer Last reply
More about correct geometric distortion
  1. There's a link to the monitor manual on this <A HREF="" target="_new">page</A>, which might help you figure out the controls.

    Have you installed the <A HREF="" target="_new">driver</A> for the monitor?

    You might find this <A HREF="" target="_new">utility</A> helpful for setting up and calibrating your display. It's not free, but it is an excellent product for this purpose.


    <font color=red>My Rig:</font color=red> <A HREF="" target="_new"><font color=green>Toejam31's Tantalizing Tantric Toy</font color=green></A>

    <font color=purple>"Procrastination on your part does not constitute an emergency on my part."</font color=purple>
Ask a new question

Read More

CRT Monitors Mitsubishi Monitors Peripherals