Sign in with
Sign up | Sign in

Reply to this thread

Forum question

Started by tetsuya23 | | 2 answers
Any Enthoo Pro case users?
Hi

Just wondering, Where did you plugged your PWM Fan hub? did you attached it to a 4 pin cpu fan header from your Mobo or used the 12v Sata? or both?

Wanna connect it to the Mobo to power the 140mm and 200mm stock fan and 2 120mm led fan from my zalman but my 4-pin Cpu fan header from my mobo is populated by 2 fans through a Y cable from my Cryorig R1 Ultimate. Any suggestions?

Thanks
  • By posting on this site, I confirm I am over 13 years of age and agree to abide by the site’s rules.

October 17, 2014 12:06:25 PM

^hmm should I transfer my Cryorig fans and connect it to the hub then put the hub to the CPU 4 pin fan header (my Cryorig is currently using that 4-pin though :/ )

Oh so,

If I connect the hub to a true PWM signal which is the one I am using for my cryorig the CPU_Fan 4 pin I then also connect the Sata 12v to power the hub?

Whilst if I use any 4-pin connector to connect the hub found from the mobo that is not a CPU_Fan, I should not connect the Sata 12v?

See all answers