BitFenix Fury PSUs Have Individually Sleeved Cables
BitFenix' Fury PSUs all come with individually sleeved cables.
BitFenix has finally introduced its Fury series of PSUs, which might not have the most revolutionary electronics, but are built with extra attention to detail with regard to aesthetics.
The PSUs are built by FSP and come with 80 Plus Gold certification. This will allow the units to run relatively efficiently, and given that they are built by FSP, they'll be pretty reliable as well. Cooling is provided by a 135 mm fan with a fluid dynamic bearing, so it'll also operate reasonably quietly.
As mentioned, the biggest highlight of the units is aesthetics. They come with BitFenix branding all over and have a big aluminum ring going around the fan area. The ring is also present on the other side, though it circles a large BitFenix logo there. The best aspect of the looks are the cables, though. These are all individually sleeved with a black mesh, which will make for some very, very neat-looking cable management.
There is one problem, though. Sleeved cables are expensive. As such, the units are a little more expensive than competing PSUs, with the 750 W model carrying an MSRP of $169. There will also be a 550 W model as well as a 650 W unit that should be distributed to shelves throughout this month.
Follow Niels Broekhuijsen @NBroekhuijsen. Follow us @tomshardware, on Facebook and on Google+.

It would be pretty enough to run on the motherboard side. Although, I'm not sure where I'd fit a bar long enough to fit all of that.
To make it more flexible maybe, though I cant say Ive really had a problem with that before.
The whole point of sleeved together cables was that you weren't looking at a rats nest of intermixed wires. Flexibility I get, but if you go out and buy any modern case, it's going to have cable management. Either tucked away on the backside of the case or through cable mounts inside the case.
I would MUCH rather see a FLAT sleeved cable that would have more practical applications.
I individually re-sleeved mine myself with black connectors, black sleeve and red heat shrink thus matching the color scheme of the installed hardware which is black and red as well ( Motherboard, PSU, GPUs, Fans, etc... )
The individually sleeved wires obviously do take up more space but you'll be able to do things like routing the between the Motherboard and Backplate - Something you can't do with a single 24 wire Sleeve because it's way too thick.
For most people it's an aesthetical thing when you can watch into the case, for others it's a necessity because of bad case planning requiring flexibility.
PSU's rape my fragile budget man.... not cool