Page 1:Step 1: Define A Purpose And Choose A Case
Page 2:Step 2: Select A CPU
Page 3:Step 3: Select A Graphics Card
Page 4:Step 4: Select A Motherboard
Page 5:Step 5: Select Memory
Page 6:Step 6: Select Storage
Page 7:Step 7: Select A Power Supply
Page 8:Step 8: Select The Finishing Components
Page 9:Step 9: Choose Your Vendor
Page 10:Step 10: Prepare For Assembly
Page 11:Step 11: Build The Platform (CPU, Cooler And DRAM)
Page 12:Step 12: Install Motherboard And Power Supply
Page 13:Step 13: Install Cables, Cards And Drives
Step 12: Install Motherboard And Power Supply
Most cases generally support a range of motherboard sizes, each with a few different mounting points. These points connect a layer of the motherboard called the ground plane to the case's mounting tray, reducing signal crosstalk due to radio frequency interference (RFI). Thus, the mounting points are usually grounded.
Misaligned mounting points could come into contact with a hot trace on the back of the motherboard, so case manufacturers usually make them removable via metal spacers called standoffs. It's important to observe the exact location of each mounting hole in the motherboard before placing a standoff in the corresponding tray location. A mistake made here could potentially damage the board, though the most likely result of an improperly placed standoff is a system that simply refuses to power on. Arrows in the photo below illustrate the matching mounting points where standoffs were placed.
The ATX form factors specifies the size and location of a rectangular plate, called an I/O shield, which fills the gaps around the ports and connectors on the back of the motherboard. In other words, the I/O shield fits a customized port selection to a standardized hole in the chassis.
Note that the upper tabs of this I/O shield hang down because it arrived in a semi-flattened state. These need to be bent approximately ninety-degrees from the surface to prevent them from blocking nearby ports during motherboard installation. The left tab in the photo below has been bent to the proper orientation. Many of today’s most popular boards instead use foil-faced foam to contact the ports.
Recheck standoff positions before inserting the motherboard at a slight angle, aligning ports with cover plate holes while guiding the board until it rests flat against the standoffs. The grounding tabs or foil-faced foam on the I/O shield will typically push the motherboard out of position, but the board should be easy to push into place. Align one hole perfectly with the standoff and affix a screw, then push the board into alignment for a second hole before tightening the second screw. The first two screws should prevent the board from twisting out of position while you install the remaining screws.
The power supply is usually secured with four coarsely threaded screws, though it’s not always mounted to the back of the case. Some enclosures relocate the power supply and use an extension cable to place power on the back. Variations in design may demand that the power supply is installed before the motherboard, as specified in the case’s manual or installation guide.
- Step 1: Define A Purpose And Choose A Case
- Step 2: Select A CPU
- Step 3: Select A Graphics Card
- Step 4: Select A Motherboard
- Step 5: Select Memory
- Step 6: Select Storage
- Step 7: Select A Power Supply
- Step 8: Select The Finishing Components
- Step 9: Choose Your Vendor
- Step 10: Prepare For Assembly
- Step 11: Build The Platform (CPU, Cooler And DRAM)
- Step 12: Install Motherboard And Power Supply
- Step 13: Install Cables, Cards And Drives