into balanced TRS inputs? XLR->TRS cables? Say I had a 828MKii and wanted to record 3 mics, it only has 2 XLR inputs. Archived from groups: rec.audio.pro () I notice some audio interfaces have either XLR and 1/4" TRS balanced inputs, or both. The MOTU...

in mind it's probably not the 'preferred method, although it sounds pretty good to me. ( so, YMMV etc ) I have a Tannoy PS115 powered sub that I use with a pair of KRK V8's ( self powered too ). The KRK's have balanced inputs but the Tannoy only has...

audio. What mic and/or accessories do > I need? Thanks. Your MD recorder most likely does NOT have balanced inputs. However, there are external devices that will interface (adapt) between balanced mic lines and the unbalanced input of your MD recorder....

a mixer channel or subgroup. The Beringer says it has balanced inputs and outputs (e.g. 2 signal wires in each jack). How can you connect a mixer's "insert" to separate balanced ins and outs of a processor like this? The board's insert jack is 3 wires...

Is the impedance of a balanced cable less than the impedan... Archived from groups: rec.audio.pro () Sorry to waste time on such a basic question - but I'm just not understanding. I tend to run balanced cables for just about everything - unbalanced only...

key is to use balanced lines, and *not* connect the shield at both ends. Again, this site (http://www.dself.dsl.pipex.com/ampins/balanced/balanced.htm) shows how to connect unbalanced outputs to balanced inputs without inducing ground loops. I have...

balanced system I guess the bottlneck is the common mode rejectio ratio (CMRR), especially at higher frequencies. Does a system like electronically balanced input provide a sufficient CMRR to cope with "pin 1" problem or ground loop issue. What about the...

it. If the cable from the source to a power amp with a balanced input is now just shielded coax, you may get an audible improvement in noise by replacing it with a cable that has two wires, so that the balanced input is bridged across the output...

It came out with 4 inputs, 2of which are balanced. I have two volume pots > and 2 input selectors, so I can mix two sources, this is to faciliate ABX > testing. It has INA2132 as balanced input receivers, OPA2134 opamps and > DRV135 as line drivers. My front...

the manual. It says the two main outputs are balanced; the Aux sends aren't and control room outputs aren't balanced, though. The 4 mike inputs and 8 line inputs ae balanced. Could you connect the speakers to the Behringers main outputs? Tim Archived...