Digital HiNote problem - unknown beep error code. Archived from groups: comp.sys.laptops () Hi all! I have a problem with my Digital Hinote Ultra 2000 notebook. It doesn't boot and I get beep error code: 3 short and 3 long beeps. I've tried to look for...

Compaq Presario 1685 - Any Beep Error Code Experts?. Archived from groups: comp.sys.laptops () I have a Compaq Presario 1685 that intermittantly won't boot up. When I press the power button, it says "Beep. Beep beep beep. Beep beep beep. Beep." then...

successfully. *Except for beep code 8, these codes are always fatal. 1 beep Refresh failure 2 beeps Parity error 3 beeps Base 64K memory failure 4 beeps Timer not operational 5 beeps Processor error 6 beeps 8042 - gate A20 failure 7 beeps Processor...

with no beep error codes, no display, no POST. very disappointed. so, i take the memory out just to see if i'll get a memory error beep code nothing. another interesting thing is that when it is on, i can't turn it off by holding down the power button for...

Three beeps, Graphics card/motherboard mass confusion. My buddy brought his computer over to have me take a look at it. On boot, it does a 1 long, 2 short beep error code. It's a VGA error code, so we thought it was the graphics card. We pulled his 9800...

i need replies The beeps are an error code - the number of beeps indicate what hardware component is malfunctioning. Could be ram, could be video card, could be something else depending on the BIOS and what codes it uses. Re-seat the ram and video card...

with Windows. This code may also be present if the device is intentionally disabled in the BIOS. "You may be able to resolve this error code by enabling or disabling the device in the computer's CMOS settings. Windows cannot override this setting....

anything, though some will give beep error codes. Also try a DVM on the power supply when it's plugged into the board, a Port-80 diags code capture card, and Wayne's suggestion of unplugging _everything_ from the board (except known-good CPU and memory)....

people think its anything but the psu. Well I fired it up without any RAM and got the correct beep code for "No memory detected". I put one stick of RAM in the first slot (yes the correct one) and got no beep code. I put all three sticks in and got no...

clearing the CMOS.. having nothing plugged in.. etc. i have plugged in an internal speaker, hoping it was trying to beep out an error code but even with no ram sticks in the motherboard i get no beeps.. (the speaker works!) so im hoping one of you guys...