How do I change RAM speed manually in BIOS?. I bought the G.SKILL 6GB 240-Pin DDR3 1600 (PC3 12800) for my core i7 920 system with the asus p6t deluxe v2 motherboard. I came across posts about having to change the RAM speed manually to 1600 in the BIOS...

does) and you have to set the higher speed manually! You have control over the basic system clock (I'm going to cal it B_CLK), once you start manually timing the MOBO through the BIOS. B_CLK times four is your FSB (once again, Front System Bus); B_CLK times...

it's "Load Optimized Defaults" [but, to keep it more confusing - not all BIOS with the "Load Optimized Defaults" fuction actually use it to set the EPP]), and some just plainly don't know the EPP exists (if it does) and you have to set the higher speed manually!...

amd athlon. Hi everyone, a friend of mine says he has a amd athlon xp but he dosnt know what number / speed it is, I read somewhere that you have to set the speed manually in the bios because it dosnt have the bus speed detection pins. Actually heres what...

didn't go high enough to enable the fan changes or something with the bios turbo controller is in-op because the RPMs stayed the same. It seems I have no ability to change the fan speed manually in bios either. Fan speeds: (constant) CPU = ~1560RPM Ch1...

use all BIOS "defaults" for this and have a good basically stable system? Thanks for any advice, bob You bought overclocked memory. By default it will run at 800 Mhz and 1.8V (which should be fine), but you'll have to set the voltage and timings manually...

models of 1600 RAM) So, set the voltage properly first. If the RAM still comes up as less than 1600, then set the speed manually in the BIOS. This should get it booting at 1600 with the stock (SPD) settings. Remember, if your settings here say 400, 533,...

some just plainly don't know the EPP exists (if it does) and you have to set the higher speed manually! Now, you have control over the basic system clock (I'm going to cal it B_CLK), once you start manually timing the MOBO through the BIOS. B_CLK times...

BIOS will default the 1066Mhz. capable RAM to 800Mhz. standard. RAM speed, timimgs and voltage will have to be set manually to 1066Mhz. What OCZ tech support states is true. Your MB will support 2 x 4GB kits or eight gigs of RAM. Manual adjustment of the...

don't know the EPP exists (if it does) and you have to set the higher speed manually! Now, you have control over the basic system clock (I'm going to cal it B_CLK), once you start manually timing the MOBO through the BIOS. B_CLK times four is your FSB (once...