MN-520 Not detected by Setup. Archived from groups: microsoft.public.broadbandnet.hardware () I am trying to set up my MN-520 wireless notebook adapter and once I get to the step where I am told to insert the adapter, I get no response from the set up...

no devices were being detected, but when I went into the raid setup util, usually press a key or two straight after bios memory check, it did detect them and I could setup my raid 0. I had to install the SATA drivers through USB/Floppy disk, when installing...

b>My Setup:</b> Asus A7V133 Athlon TBird 850 256MB SDRAM PC133 CL2.5 @ 2 ATI Radeon 32MB SDRAM IBM 75GXP Deskstar 30GB SB Live! Value 3Com 3C905B-TX NIC HP CD-Writer 9150i <b>Partition setup:</b> 1 Primary (Windows 98SE) FAT32 - 5.84, using 760MB...

I then deleted all the files in C:\Program Files\Internet Explorer. I then downloaded the web install for IE. Now, when I click on the install, it tells me that a newer version of IE has been detected and setup needs to close. Is there a way to get IE to start...

video card set the right resolution? Thanks for the help. Yes you can run that resolution, and it should auto detect it once you have the monitor connected and properly detected/setup. If it still doesn't work you can manually add support afterwards. Thanks...

have installed the "bridge connector"?? :oops: Anyway. My problem was all within the control panel. I had to go into advanced 3D settings and manually check every setting. It turned out that although the mobo detected the set-up and asked me to enable...

Computer System for Digital Photography: MS-Windows, Apple... Archived from groups: rec.photo.digital () I need a new computer. The major jobs are internet serfing and digital photography. What're the pros and cons between these three systems: MS-Windows,...

then prompts me for a new install. Is there anyway to avoid this in order to preserve my OE mail/newsgroups as well as having to reinstall all of my applications? Actually, if it would just detect my setup stuff (network etc.) and import my mail from...

way to set it up is to install ME onto the C drive and then from within ME install XP as a new installation onto the E partition of C.XP will detect ME and setup the dual boot without seperate boot loader.XP will also overwrite the MBR of the C drive...

updater located adapter and is able to update Boot Firmware, but never the Runtime Firmware. MN500 and MN740 are within 5 feet of each other, line of sight. Xbox is turned off during all this. I cannot understand why it detects the setup and shows...