COD 4 Display problems and rebooting PC. Hey internets, I am having a few ongoing issues with COD 4 (actually a few games i play on my PC share this problem) Display problem, when the map is loaded and all the textures generated, etc. the display starts flickering...

the Display problem.... Reboot to Safe Mode Open Device Manager Remove ALL Display Adapters Remove ALL Monitors Reboot to Normal Mode - Windows will reinstall the required drivers - hopefully curing your problem. -- Noel Paton (MS-MVP 2002-2005,...

Display Resolution Resetting Problem. I was visiting a friend over the weekend and while I was there he decided to reinstall his PC. He got everything reinstalled okay barring one problem. On rebooting the PC, the display settings always seem to to revert...

the problems I have been having appear randomly, I do seem to be | able to Restart from Shutdown with fewer snags than by rebooting. | | During reboots, the Prompt to select which mode (i.e. Normal, ... Safe Mode, | etc.) always appeared once only until...

Problems when rebooting. I built myself a system a little over a year ago and everything's been running fine until recently. About a month ago I went to reboot my computer (from within Windows) and it wouldn't boot back up. It beeped once as normal but never...

I didn't have any problem with my internet > connection, because the first thing I did was start downloading &> installing > the windows updates. When it was finished installing, and wanted to > restart, I started having problems with it rebooting again....

on the monitor for half the boots). Ok, so when I did get a visual, I formatted and installed windows on the hard drive, no problem. Then I went to reboot.. Now the computer just stays rebooting itself after about 10 seconds. There is no display whatsoever....

microsoft.public.windowsme.general () I suspect that you have driver problems...... Reboot to Safe Mode Open Device Manager REMOVE all yellow or red-flagged entries REMOVE all entries in the 'Other Devices' branch - if present Reboot to Normal Mode...

corrected the problem but reboot is required. Setup cannot continue. Press any key to exit." I press any key and the system reboots and the windows installation begins all over again, with the same result. Rebooting with a Win98SE startup floppy...

to be available in all profiles, then rebooted into Normal Mode. Which it did, but still apparently with the SiS display drivers active. This was about 20 minutes ago, but who knows how long it'll last. Any thoughts as to what may have caused all...