Dlink : "Access Point" or "Wireless Client" mode?. Archived from groups: alt.internet.wireless,uk.telecom.broadband () I have a wireless modem/router at home (Dlink DSL G604T) and a PC with an access point (DSL-2000AP+) hanging off it's ethernet port. There...

Point and the router are all disabled. They are on the same network (192.168.2.0) The access point has a number of "modes": ..Access Point ..Wireless Client ..Wireless Bridge ..Multipoint Bridge ..Repeater The default is "access point". There...

he bought 2 D-links 624+ routers. >>> The problem is that they are *both* access points. To connect >wirelessly, you need one to be a client device. I suggest that what > you need is an access point with a 'wireless client bridge' mode, or > one...

2. ethernet to wireless client. No drivers required on the Linux > side. This will let you talk to an access point or wireless router. > None of the wireless routers have a client mode. However, many of the >access points do have a client mode. See...

is the real problem. >It seems my options to remedy this are running cat5, a range extender, >stronger antennas, or a wireless access point. 1. Run CAT5 upstairs to the computers. 2. Run CAT5 upstairs to a 2nd wireless access point. 3. Setup a...

well. Connect to a wireless-Ethernet bridge, or a multi-mode access point in Wireless Clinet or AP Client mode, and away you go. Most such current wireless devices aupport multiple MAC addresses, so you can connect multiple devices behind a switch....

go 5 meters without an active repeater. A friend was using a 6" diameter coffee can, which I found to have lower gain than the 4" diameter two coffee can setup, but the larger can was easier to point at an access point about two blocks away. Bob Alston's...

to DLINK wireless router di-624 rev c to External Aerial to External aerial to DLINK access point 2000ap+ in client mode to DLINK wireless router di-624 rev b to My computer finally. The problem is my computer...

my two D-link access points work as wireless bridges, but because they are different models, I don't believe this is supported. The two access points are a DWL-900AP+ and a DWL-2000AP I currently have the DWL-2000AP as an access point and the DWL-900AP...

routers and access points are normally made to talk to wireless clients, not other routers or access points. The DLink DI-514 is a very simple wireless router and can only act as a wireless router. Same with your WRT54G using the stock firmware. However,...