uncore and DRAM at .5 volts. Since uncore is usually defaulted to 1.150, 1.65 is usually said to be the maximum safe DRAM voltage (1.150 + .5 = 1.65). But the important thing is just the voltage drop between these two. A large voltage between these will...

BIOS DRAM voltage set to 1.62, 1600 MHz (10 x 160 BCLK), 8-8-8-24 When I run CPU-Z, it says my core voltage is 1.020. Is this the same as Uncore voltage? In this case, is my uncore at 1.020 while my DRAM is at 1.62???!!! Please advise. Thanks. There...

ASRock P45XE motherboard memory voltage and compatibility question.. I have a dual kit ram of 4GB A-DATA Vitesta 1066+Mghz DDR2 (2x2GB) that asks 2.1 - 2.3v voltage. I am planning to buy the ASRock P45XE motherboard and just want to be sure that the ram kit...

Increased this and just matched the settings for QPI/DRAM Core Voltage) CPU PPL Voltage: 1.80 QPI/DRAM Core Voltage: 1.33125 DRAM BUS Voltage: 1.60 ...

the memory running at 1600mhz at 1.5 volts. Seems the lower voltage, causes the memory to behave erratic. So i set Dram voltage to 1.66 (gigabyte exetreme mother boards 1.64 or 1.66, can't hit 1.65 on the nose). But shouldn't matter because within 0.5v...

increases the voltage of the memory controller and at the same time reduces the voltage difference between DRAM signal and memory controller. When the DRAM signal voltage is too high it burns the memory controller on the CPU, hence raising the memory controller...

CPU voltage: 1.20 QPI/DRAM Voltage 1.25 DRAM Bus: 1.64 I've had no problems with this setup. Runs Prime95 for hours and never crashes. So I tried this one recently: bclk: 160 pcie freq: 100 CPU voltage: 1.18125 QPI/DRAM Voltage 1.23125 DRAM Bus:...

DRAM settings on ASUS P6T Deluxe V2. OK here is the question if I set the Multiplier to 20*200 and Dram Frequency to 1603 I cannot get it to work I have the Dram voltage at 1.65 CPU Voltage at 1.250 QPI at 1.250 The setting work fine for 1203 MHZ My Memory...

pictures of my BIOS config options. [img][/img] [img][/img] What i was refering to was in picture 3 labeled "DRAM Voltage" however you also have "NB voltage" and "SB voltage"? Im sorry to be a pain but i dont want to do anything wrong as i...

I know if it is stable after I stop Prim95 tomorrow? If it doesn't crash or what? Also does that voltage look too high/low to anyone? I kinda just threw 1 out there to see if it worked. Set timings to 4-4-4-12 and dram voltage to 2.0v and cpu voltage to 1.300,...