Hard Drives, Startup and More. Hello everyone, I tried posting over in the Windows 7 section but I think I'll have better luck here (I hope). Ok let me start with what I got: a GA-K8N Ultra 9 Gigabyte Motherboard (AMD Socket 939), 3xSATA II hard drives 1xSATA...

IDE drives startup problem. New set up with the GA-MA790-X-UD4P board. On the IDE side, I have the DVD-R/W in the boot path. When I hook up an IDE hard drive, neither are recognized. HDD alone and it is recognized. What could I be missing? A jumper issue?...

Extra drives on startup. We have HP a1247c computers at work and every time they start up they find additional external hard drives that don't exist. They'll disappear if we select "remove hardware" and "stop" them. It's not too big of a deal... more of...

G6-400 not seeing DVD/CD-RW drives at startup. Archived from groups: alt.sys.pc-clone.gateway2000 () I have an older Pentium II 400 mhz system that is not recognizing either the DVD or CD-RW drive at startup (before Windows loads). Consequently, Windows doesn't...

1. Hook up DVD drive and set jumper to the master position. Did it. >> 2. Put Windows Startup floppy in floppy drive. Did it. >> 3. Choose "With CDROM support" at startup. Did it. >> 4. Note letter it assigns the drive. Not sure about this. Here is what...

Drive' in 'my computer?' This happens even when a system is >powered up with the networked system already online (supposed to >reconnect on startup). This is by design. Windows will not reconnect the drives on startup but on the first use. -- (tm)...

a go at partitioning and backing up my computer, what a big mistake! Cancelled out half way through and am now stuck 'invalid system disk message' Have used the startup disk can get into DOS but can't start Windows. I do seem to have a partition called...

disk, 2. 1st IDE device, 3. Atapi CD-rom, and 4. network. Now at startup its asking for a disk in drive A. How do i get it to startup normal again. Thanks Archived from groups: alt.sys.pc-clone.gateway2000 () 1. 1st IDE device Ty "Sunshine"...

lead on Startup Cop. I was wondering if some utility could restructure the startup order so that the mapping would come last. Yes XP, forgot you were on 2000. There should be an option to reconnect mapped drives at startup. Unselect this and it wont auto...

would have to go and manually copy the new file into the device. I have tried to get my application to run at startup on the device by copying a shortcut into the startup folder for the PPC. However, this fails and says file not found. I have tried...