Cpu fried! or so it seems. So i boot up at 12pm...i play diablo2 for 5 hours straight. Im in the middle of a game when my monitor goes into powersave. I look down and my pc is off. Although, the power led is still bright, and the mobo power led is still on....

it!!! you are too smart, way too smart. drink some cold water dh. it'll help bring down your temp and your face might get its color back. i didn't know how badly i've fried you, but it seems its bad enough you are getting PMS over it werx is my...

the actual 1200) Suddenly one day the system couldn't post at all, just beeps continuosly (short beeps). Have tried to remove everything except mem and video, same result.. Also removed the cpu to see if it's fried, but it seems ok to me... Any suggestions??...

its the last 2 channels 1 white 1 blue that will not post. After seeing Mikes posts and searching the net some more. My feelings are getting worse. What I think is happening is the memory controller is not totally fried. It seems to only disable 1 of...

I think Wingy got bored with it.. Thanks, but you can keep them. I replaced them with a cybernetic replacement. Not perfect, but at least I can digest stuff again. *goes back to his motherboard steak and P4 fries* It seems to be 1/4'' ID & UV reactive......

by a spark and a bit of smoke. Incidentally, the board continued to re-start and I was still able to enter the bios. At this point sensibility outweighed curiosity and I shut it down. The board is definitely fried now. On inspection, there did not seem to be...

I always thought that using thermal compound, the right HSF, standard voltage, monitoring temps, etc. would be enough for avoiding a fried CPU. Well, it seems that's not always true ... I was overclocking a K6-2+ 450. Everything runs perfect at 500 and 550....

for about a year now. First I must say that you need to make smaller posts. Second, I wonder how long you had this overclocked. If it wasn't much of a long time, then you probably got it back on wrong and it fried. Otherwise it was a circuit that burnt...

I have always avoided it. If a machine seems fried, I usually just reformat, reinstall, restore, etc. Yet on the MS site it gives instructions for a repair install (KB315341), and it seems to suggest that the only thing that needs to be done afterward...

panel switches connected it is still doing nothing, fans twitch but thats it. The behaviour is the same with both the Antec and the Sparkle. Looks like a fried mobo, it if doesn't start beeping madly due to the lack of RAM and vidcard. Sometime's electronics...