1187 search results for help speakers measurement
OK
Ad
  • Help With Speakers Measurement. - Forum

    Help With Speakers Measurement.. I was looking at an article at Toms' Hardware reviewing the Logitech Z-2300 THX 3-piece speakers. The measurement chart shows a drop at 500 Hertz at around 4 Decibels, is it good? I listen mostly to music CDs, is 500 Hz the...

  • Help measuring frequency response for a speaker system - Forum

    room instead of an anechoic chamber; I know you are trying to mitigate the effects by close miking, but that doesn't help - a speaker is not designed to be flay close up. Then you are using tones; this is virtually impossible with speakers. You need to...

  • BOSE speaker help needed please - Forum

    BOSE speaker help needed please. Archived from groups: rec.audio.opinion,rec.audio.tech,rec.audio.misc,rec.audio.pro () I have a BOSE Acoustimass 7 (3 saterlite speakers and bass speaker) I brought this for surround sound. I have two BOSE VS100 small sized...

  • Kudos to Arny Krueger - Forum

    this relationship much >> better by measurements than is possible by ear. > So _any_ amplifier with low measured distortion will not audibly color the sound > in any way, is that it? The trick is measuring all relevant distortions. Archived from...

  • Am I crazy for wanting to build my own speakers? - Forum

    shuttle. I've read one book by David Weems, Designing, Building, and Testing Your Own Speaker System, it's the only book on the subject at my local library. Being a total neophyte, the book was of marginal help, so I went looking on Amazon. The speaker...

  • Speaker frequency response measurements - Forum

    Speaker frequency response measurements. Archived from groups: rec.audio.tech () Is there a standard input level(or output level) at which speaker frequency response measurements are made? I know that efficiency measurements are made with a standard 2.8...

  • Arny or other techies - Frequency response graphs? - Forum

    to spec and the speakers are the 15 ohm version using B110-A's and T27-A's I used RMAA (Right Mark Audio Analyzer) to run some tests through the LS3/5A's into a single Behringer ECM 8000 test mic. The speakers and mic are set up in an approximate equilateral...

  • Doppler Distoriton? - Forum

    Doppler Distoriton?. Archived from groups: alt.music.home-studio,rec.audio.tech () Here's the results of some speaker measurements that I made tonight, based on passing 50 Hz & 4 KHz mixed 1:1 at about 1.2 volts rms, through a Peerless 6.5 inch woofer with...

  • Eqing Monitors? - Forum

    low end where the speakers drop off. >My intention was not to fix room problems. Perhabs there are some >little, but not that much. I never measured it, but I think I know how >they would sound. If you had speakers that measured flat in an anechoic...

Ad