XP failing to install on Promise Raid 0. Hi PC spec: P4 2.8 1.024MB DDR RAM Asus P4C800 deluxe mobo 2 x Maxtor 120GB Sata HDD Bios v 1.008 Latest Fastrack drivers 1.0.30 Problem: I am trying to install XP onto the Maxtor drives. I have created...

XP installation with promise raid. hello, i´ve 2 WD drives ( same model) in a raid 0 setup . the raid is reported FUNCTIONAL by the controller BIOS , if i boot from a dos disk ( like w98 one) i can fdisk the array, and format the disk normally. this is pretty...

the drivers installed for the IDE Promise raid card I will use, nor will the startup files be correct. my question is, can i get windows to re setup and and install the correct drivers without re installing the entire op system?? perhaps some way of...

Even with the RAID controller disabled in the BIOS, the system might need the controller driver installed at the beginning of the text-based portion of Windows setup. Normally, the primary hard drive would be installed on IDE 3 if RAID was enabled. Your...

now - no more updates from RedHat. Go with the current release of Fedora or something. I can't say which is going to be the easiest with a HighPoint controller, but I found Mandrake deals nicely with installation on Promise RAID (Debian is a fricken bad joke...

which I am trying to avoid. Getting XP to install> with the Promise RAID driver is a pain I'd rather not go through again > if I can avoid it. I've seen a number of posts in this group from people with similar problems after installing SP2, but no solutions....

RAIDs are configured properly. The Promise RAID has got 2 HDDs also combined to one RAID1. If I would put the operating system on this RAID1 (the one from the Promise RAID) I suppose, that the onboard RAID won't be loaded either. Any more ideas? What does...

but no longer RAID. The Promise cards are now pulled. IDE RAID has been troublesome.. as before attempted an 80GB pair with Adaptec 1200A RAID adapter which seemed to work.. but bad drives caused lots of trouble. Went to Promise adapters instead and have...

Promise RAID. Hi - I have just installed the MSI KT7 mobo w/ Promise RAID controller. I have one IDE drive on the regular IDE channel (i believe it is channel 1) and two drives on the RAID contoller (one on channel 3 and one on channel 4, both are set as master)....

card so I had Internet immediately) Downloaded and installed the latest Via 4-in-1 drivers Downloaded and installed the latest Promise Raid drivers Installed Video drivers from the CD Downloaded and installed the SB LiveWare 3.0 drivers. That's it, no...