How to use Main Inserts. I'm new to sound systems, so please have patience. I have a 2 channel graphic EQ and 2 channel compressor and want to process the main mix and monitors. How can I run these to the main inserts? From where on the mixer do I get the inputs...

Main Insert. Archived from groups: rec.audio.pro () Just purchased a Mackie 1604VLZ Pro for live use, and was wondering if anyone could explain the advantage of using the "Main Insert" for EQ and compression, as opposed just running the main mix outputs...

is fine. it is verified by the main output meters...when the right side cuts out...so does the meter. any ghost users/ tech minded folks have experience with this or similar? i did a search...we're checking the main inserts, cleaning the fader and...

jacks on a computer? IME its more advantageous to obtain a small mixing console such as the Behringer MXB1002. Then you can plug the SM57 or SM58 (or hopefully an OM-5 or OM-6) into it, and hook the main or insert outputs of the console to the PC line-in...

replace an old system... >> Please can somone confirm all items are compatable with each other and > suggest a suitable wiring method for the eq/rev5 Desk main out ->Main Amp Desk main insert -> EQ Desk send 1+2 -> Foldback Desk send 3 -> Rev 5 -> Aux...

it will get >the job done. You may need an external amp to use the crossover, unless you have a mains insert on the Mackie that you can use to intercept the signal between the main out and the power amp. >Obviously, I'm a novice at this. Any advice...

way to check your power supply. It's called the paper clip test. Disconnect all power supplies cables. Make sure the psu is turned off. Plug the PSU into the wall socket (mains). Insert one end of a paper clip into the green wire pin on the 24 pin power cable...

allen & heath flaky inserts. Archived from groups: rec.audio.pro () Hey everyone, At my church we have an Allen & Heath GL2200 series mixer which is about 6 or 7 years old, and several months ago, we had a TRS channel insert go flaky, to the point where...

few questions: >> 1) where is the "classic" place to put one? (a channel insert, > between the main outs of the mixer and the power amp, etc.) Depends what works best. Mike said channel insert, and that might work in some cases. OTOH, I've been known...