now is, do i need to connect a female molex power connector to the male molex connector on the motherboard? Refer to the images below. Molex connector shown circled in red ...

the red one to the red hole in the Molex connector, then black to black. It is MOST unlikely that whatever happened to your mobo did any damage to the power available on the Molex connector from the PSU, so this should give you a guaranteed 12 volt supply to...

but they have it that way for a reason.......... to plug 2 male molex's into it. Look around and locate a molex connector that has a "y" in it to use for your cd-rom/floppy or whatever and make sure you plug 2 into the video card "y" connector. ok what I did...

splits into 2 female molexs, does that mean i need to connect both 12v rails to them? Bump....anyone? :P ...And my graphics card has a male molex connector.. The Y-connector is supplied in case you need to share a power cable from the PSU between the GPU and...

case fans I installed so I can get the first 2 pre-installed case fans connected first. The molex connectors that came with my fan are male/female on each connector. I used a cable that came with my PSU which has 2 molex connectors (male/female) and a female...

Powering male molex fans w/ male molexes from PSU. I have a Hiper 580w PSU, and an Antec 9000 case. The fans are all powered through male molex connections. How in the devil am I supposed to connect them to the PSU? I can't find any converters online for...

problem. Like I said, those Molex connectors on the fans probably are a pass through, so you shouldn't need any extra splitters. Also, a 750W should have enough Molex connectors anyway. Been a while since I have seen a Falcon. Alright, there shouldn't be a...

would be needed. And I used only one Molex and it works. Was just wondering why some people seem to think you should connect both Molex connectors Because there are 2 molex connectors on the adapter. You misunderstand the manual, its saying that it does not...

in a male and female 4 pin molex connector instead of the small 3 pin fan connector for the motherboard. Can I hook these fans directly to the PSU? The decorative LEDs on the front of the case also end in the same molex M&F header. Can I daisy chain all these...

from the 6-pin header to a male molex, and then 4 wire to a female molex. So only one molex provide the power. The usual 6-pin adapters I saw so far in pictures on the net have 6 wires from the 6-pin connector, spliting to 2 female molex connector (which...