Midrange Speakers. I'm interested in midrange 2.1 or 4.1 speakers, with an emphasis on accurate music reproduction (but a little gaming too!). The Z-560 seemed inappropriate (not much of a music quality upgrade from my old Altec Lansing 495), and the Altec...

BOSE Acoustimass 7 (3 saterlite speakers and bass speaker) I brought this for surround sound. I have two BOSE VS100 small sized speakers at the back of the room, near the ceiling. I read in a article that the frequency range is: Base module 46Hz to 202Hz...

high frequencies or that a mid-range speaker CAN'T reproduce lower freqencies....they just aren't made for it. In fact some manufacturers (like Lowther) make speakers that are made to handle all freqs. Anyway, a three way system does not automatically...

Randi/Atkinson addendum. Archived from groups: rec.audio.high-end () In a recent post I speculated about the web source of quotations Randi had from Mr. Atkinson, here is the source, you may have to drill down a bit to find the specific posts: And...

have come to accept that "PC speakers" are supposed to be plastic, high-distortion, narrow bandwidth little toys. Oh well. Some of us still remember what good speakers are. And some of us actually hook up "real" speakers to our PCs. It really works! Try...

that going high end computer speaker is not worth for everyday users. My recommended range is about ~$120-200'ish. Here are some of my suggestions for the midrange speakers: Logitech Z-2300 (if you want boomy bass) Klipsch Promedia 2.1 (bit better than...

not that simple of a comparison. There's a well-known joke that goes something like "a fast woofer is a midrange speaker". In the case of subwoofers, consider the effect of moving the natural roll-off of a speaker driver from 800 Hz to 2 KHz, when the speaker...

build a pair of reasonable speakers within your budget, out of a single 8x4 sheet of plywood. You'll need Sheet material Glue Screws Speaker clamping kits Paint Wadding Speaker terminals Crossover components Internal wire Estimate the cost...

mid-range speaker polarity is often inverted because that's the way it works best. Perhaps modern digital crossovers and the contemporary knowledge of time-aligned cabinet design (instead of just mounting all the speakers on a board with holes in it) have...

months ago I inadvertently blew the voice-coil on one of my Neat Petite bass/midrange speakers. Contacted Neat in Britain, seeking to buy a replacement speaker, only to be told that I couldn't replace one -- the design had been upgraded and both would have...