in any DMA mode. Attempts to force it into DMA mode via the hdparms command result in an error message saying that I'm not allowed to set the DMA mode for that device. I suspect a problem with the drivers for my motherboard. It's relatively new, whereas...

matter if I use different channels, WPA2 or no encryption, or pure N or mix mode, the max thruput I can get is always about 10 Mbps while I can get steady 20 Mbps in pure G mode. Also there are no other devices connected to the network and the Zotac is about...

you the options of going to Normal mode, Safe Mode, etc. Actually, I use this as I have trouble getting into Safe Mode otherwise and it only takes a sec to press "Enter" when Normal mode (the default mode) is highlighted. If you do nothing, the puter...

Archived from groups: microsoft.public.windowsme.general () USB Input Devices Do Not Work in Safe Mode or Real Mode Similarly, it is unlikely that you can write to CD-R, or CD-RW, in Safe Mode. The devices may be visible in Device Manager, but 32-bit...

settings. Make sure these settings are correct in Control Panel, and then try starting Windows again. While in safe mode, some of your devices may not be available. To proceed to work in safe mode, click Yes. If you prefer to use System Restore to...

of the contents of the CDs showed up every time I tried it. Your next step was to try copying something from the CD to the hard drive. I don't know how to do this in DOS mode. I appreciate your patience with me and this problem. Randy Williams "Gary...

or maybe before that (my apologies), the CD's stopped working in Windows. Also, in regular mode, there are no devices listed in Device Manager, but there is a long list of entries in Safe Mode. That seem strange. Please, what should I do? PS. I...

the wiring? I'd also reinstall the IDE tree. What I usually do is restart in Safe Mode, go into Device Manager, remove ALL drives, remove ALL controllers (except FIFO's, which can't be removed in DM and usually don't need to be) and the System device...

In Device Manager> Modems, what does it show there? Is you modem listed, and does it show any errors in Device Status on the General tab, when you select it and click Properties? On the Modem tab, what port does it show it is using? In Control Panel...

old drvie too. Any ideas? >>> Archived from groups: microsoft.public.win98.gen_discussion () Boot to Safe Mode and remove any/all drives/controllers in Device Manager. Reboot and Windows will redetect/reinstall the controllers/drivers. -- Brian...